Step 1:
Secure the rear of the HiSUN Strike 250 by using a floor jack and raise the rear of the UTV until the rear wheels are off
of the ground and you are able to place jack stands under the frame. By placing the jack stands on the frame/chassis,
you will allow the rear swing arm free to swing up and down as you install the rear plates. Keep in mind to have the
rear wheels at least a few inches off the ground, as you are going to lower the axle when you install the rear plates.
Step 2:
Remove the rear wheels and place them aside, this allows you easier access to installing the rear lift plates, but it can
be done with the wheel still installed but gives you more room to work.
Step 3: (see pic below)
Loosen the three bolts that hold the lower rear shock into place, and the axle adjuster block upper bolts as well. These
bolts and nuts will be replaced with new ones in the kit.
Loosen the upper shock bolts, to allow the shock to move out of your way freely. The upper shock bolt will be reused.
Step 4:
Loosen the small 8mm bolt holding the rear brake hose and parking brake cable onto the swing arm, you will need to
move the cable/hose out of the way for a little bit.
STEP 3
STEP 4
