Hisun 450ATV-2, Руководство по обслуживанию

Страница: 97 / 115

97
5. Detach Oil Pot ( connected with 3 Rubber Pipes)
5. Take out Oil Pot from the Frame (connected with 3 Rubber
Pipes). (Figure 4-7-)
4.7.2.2 Inspection of Oil Pot:
1. Check the Oil Pot sealing with 0.03 MPA Compressed Air.
Replace Oil Pots with sealing defects.
2. Check if Rubber Pipe is torn, aged, worn out or distorted.
Replace defective Rubber Pipe.
3. Check if the hoop on Rubber Pipe is loosen.
Replace loosen hoop.
4
、
Clean Oil Pot after inspection.
4.7.2.3 Assembly of Oil Pot
1
、
Connect Rubber Pipe to Oil Pot with the hoop.
2
、
Connect inlet and outlet steel pipes to engine with M6 Bolt.
3
、
Connect the third rubber pipe to the oil pipe fitting located at the
end of engine and fasten with a hoop.
4
、
Tighten the Oil-discharge Bolt of engine.
5
、
Pour 2.8L SAE10W-40 Engine Oil into Oil Pot.
6
、
Start engine to check for any leakage.
4.8 Disassembly, Inspection and Assembly of Parking Mechanism.
4.8.1 Disassembly of Parking Mechanism