Hisense RT-41WC4SAB, Инструкция по эксплуатации

Страница: 6 / 36

6
Warning! Before installing, read the
instructions carefully for your safety
and the correct operation of the appliance.
Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight, etc.
Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand new product, then
dry thoroughly.
Electrical connection
Caution! Any electrical work required to
install this appliance should be carried out by
a qualified or
person. authorized
Warning!
This appliance must be grounded.
The manufacturer declines any liability should
these safety measures not be observed.
First use and installation
Cleaning before use
Installation Positioning
Climate class Ambient temperature
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
75mm
100mm
100mm
Important!
For this
reason, space should
be available around the . It is
advisable for there to be 75mm separating
the back of the
to the wall and
at least 100mm of space on its two
of over 100mm from its top and a
clear space in front to allow the doors to
open 130°.
It is necessary to have good
ventilation around the refrigerator to allow
for the dissipation of heat, high efficiency,
and low power consumption.
sufficiently cleared
refrigerator
refrigerator
sides,
a height
This performs well from
The appliance may not work properly if it is
left for a longer period at a temperature
above or below the indicated range.
appliance N to T.
Fixing the handle
Before you use the product, please check
the handle
. If the handle
is loose, you should fix it with the hexangular
screwdriver in the clockwise direction, then it
can be used normally.
of the refrigerator
Appliances must not be exposed to rain.
Sufficient air must be allowed to circulate
in the lower rear section of the appliance,
as poor air circulation can affect perfor-
mance. Built-in appliances should be
positioned away from heat sources such
as heaters and direct sunlight.
Leveling
the floor. You can also adjust the level by
the Adjustable bottom feet part
the front (use your fingers or a suitable
spanner).
unscrewing
in
The appliance should be level in order to
eliminate vibration. To make the appliance
level, it should be upright and both
adjusters should be
with in stable contact