4
TV components
2
Lay the TV (screen down) on the edge of the table or bench. Make
sure that you put a soft cloth or cushion between the table or
bench and the TV.
3
Align the base with the TV, then secure the stand to the TV with
the 4 screws provided.
4
Carefully lift the TV into an upright position.
To remove the stand, see the following procedure.
The TV must be attached to desk so it cannot be pulled in a
forward/backward direction,potentially causing injury or
damaging the product.
NOTE:
Be sure to follow the instructions,incorrect installation of the stand
(pedestal) may result in the TV falling over.
Removing the stand
Attaching the TV to a desk
You must remove the stand before you can wall-mount the TV.
Note
To remove the stand:
1
Lay the TV (screen down) on the edge of the table or bench. Make
sure that you put a soft cloth or cushion between the table or
bench and the TV.
2
Remove the 4 screws holding the stand to the TV, then remove
the stand.
Installing a wall-mount bracket
If you want to attach the TV to a wall-mount bracket (not provided), you
Warning
only. To reduce the risk of hazards, do not perform any servicing other
than that contained in the operating instructions unless you are
To install a wall-mount bracket:
1
Lay your TV face down on a table or bench. Make sure that you
put down a soft cushion or cloth so that your TV does not get
2
Remove the pedestal stand. See “Removing the stand” above.
3
Secure the wall-mount bracket to the back of your TV using the
four screws provided with the bracket.
TV components
Front and side controls
Item Name
Description
Power indicator
The light shows whether the TV is on or in standby
mode.
Remote control
sensor
Receives signals from the remote control.
Please do not block.
MENU
Display the onscreen display(OSD) or Exit to close
the OSD.
INPUT
Select the
INPUT
menu.
VOL / VOL
Volume adjust button. To increase or
decrease the volume.
Channel select button. To increase or
decrease the channel.
CH /CH
(power)
(standby mode).
5
6
7
1
2
3
4
Screws-M5×L(table depth + 8~10mm)
Example:Table depth - 15mm: Screws-M5×25
14.17inch(360mm)
4-Screws
table
3.54inch
(90mm)
stand
screw
stand
screw
LHDN32V88MH / LTND42V77MH
stand
scratched.
wall mount screws
7.87inch(200mm)
7.87inch(200mm)
0.39inch(10mm)<hole size on table<0.59inch(15mm)