Placing the dishwasher
The dishwasher can be installed under a worktop or freestanding. Make sure the area on which the
dishwasher is to be installed is firm.
Adjust the height and slide the dishwasher into place
24 mm
Freestanding
1. Make sure the area on which the dishwasher is to be installed is firm. Adjust the dishwasher's
height using the four feet so that the dishwasher is level. The dishwasher may lean no more than
5 mm.
2. Once the feet are properly adjusted, tighten the anti-tip feet firmly against the floor.
Anti-tip feet
Built-in
1. Start by measuring the height from the floor to the bottom edge of the worktop.
2. Measure the height from the floor to the top edge of the dishwasher.
3. Adjust the front feet by turning them clockwise to raise and anticlockwise to lower the dishwasher.
Lean the dishwasher forwards a little and adjust the rear foot with the screw at the front of the
dishwasher. Turn clockwise to lower or anticlockwise to raise.
4. Check that there is an air gap of at least 3 mm between the underside of the worktop and the top
edge of the dishwasher.
5. Slide the dishwasher into place.
•
Pull through the drainage and supply hoses when the machine is slid into place.
•
Check that the hoses have no kinks or sharp bends, and check that there is nothing that can
damage the hoses.
•
Check that the machine is installed such that the door opens freely, otherwise door lock
functionality may be disrupted.
6. Make any final adjustments to the front feet (the dishwasher may lean no more than 5 mm).
32
