Display Controls
Standby Mode
A
B
C
D
E
F
G
Temperature Measure Change (°F / °C)
You can set the temperature you desire by pressing
the buttons " " or " ". When you press the button
for the first time, the LED readout will show the
previously set temperature. The temperature will
increase1
℃
or 1
℉
each time you press the UP
button and will decrease 1
℃
or 1
℉
each time you
press the DOWN button.
NOTE:
·The appliance doesn’t work properly if the set
temperature is higher than the ambient
temperature.
·The temperature range is from 1
℃
(34
℉
) to 10
℃
( 50
℉
).
·The temperature preset at the factory is 4
℃
(39
℉
).
·When you set a temperature, you set an average
temperature for the whole cabinet. There may be a
2
℃
to 3
℃
variance between the top and bottom
shelves of the appliance.
Temperature regulation
Standby key
℉
and
℃
Change key
Light On/ Off key
Temperature Indicator
Cancel alarm key
Temperature control key -Down
Temperature control key -Up
8
“Light On /Off key”
When you do not plan to use this appliance for a
period of time, you can save energy by entering
the standby state.
·To enter standby mode, press and hold the
standby key for more than 3 seconds. The buzzer
will beep and the display board will show "OF".
·To exit standby mode, press and hold the standby
key for more than 3 seconds. The buzzer will
beep.
NOTE:
In standby mode, cooling will stop. If you do
not plan to use the appliance for a long time, take
out the beverage, and unplug the unit.
You can turn the interior light on or off by pressing
this button. After closing the door for 10 seconds,
the light will turn off automatically, so wine is not
exposed to light for too long.
You can change the temperature display setting
from Fahrenheit to Celsius degrees by pressing the
marked ,and vice versa.
The control panel, shown above, is at the top of
the beverage cooler.
·Each time the power turns on, the display panel
will light keys and icons for 3 seconds, beep for 1
second ,then enter the normal display status.
·Icons are always lit when press the key on the
panel.
·The display will turn off if no button and no action
is taken to open or close the door for 60 seconds .
·Any button press or open door action will light
screen .
·while press the key in the un-light screen state. Do
not change the settings.
·Each valid button press emits a short sound.
·The corresponding temperature setting is
reflected in the display, and the setting takes
effect and is stored after 10 seconds of operation
without pressing the key