background image

Cleaning and Ca

e

For hygienic reasons the appliance (including 

exterior and interior accessories) should be 

cleaned at least every two months. 

A CAUTION 
The appliance must not be connected to the 

wall outlet during cleaning. Danger of 

electrical shock! Before cleaning, switch the 

appliance off and remove the plug from the 

wall outlet socket. 
Exterior cleaning 
To maintain good appearance of your 

appliance, you should clean it regularly. 

Spray water onto a cleaning cloth instead 

of spraying directly on the surface of the 

appliance. This helps ensure an even distribu­

廿on of moisture to the surface. 

Clean the doors, handles and cabinet 

surfaces with a mild detergent and then wipe 

dry with a soft cloth. 

A CAUTION 

Dont use sharp objects to clean with, as 

they are likely to scratch the surface. 

Dont use Thinner, Car detergent, bleach, 

ethereal oil, abrasive cleansers or organic 

solvent such as Benzene for cleaning. They 

may damage the surface of the appliance 

and may cause fire. 
Interior cleaning 
You should clean the appliance interior 

regularly. It will be easier to clean when food 

stocks are low. Wipe the inside of the fridge 

freezer with a weak solution of backing soda 

and water, and then rinse with warm water 

using a wrung-out sponge or cloth. Wipe 

completely dry before replacing the shelves 

and baskets. Thoroughly dry all surfaces and 

removable parts before pu廿ing them back into 

place. Although this appliance automatically 

defrosts, a layer of frost may occur on the freezer 

compartments interior walls if the freezer door is 

opened frequently or kept open too long. If the 

frost is too thick, choose a time when the freezer 

is nearly empty and proceed as follows: 

l. Remove existing food and accessories baskets,

unplug the appliance from the main power and

leave the doors open. Ventilate the room

thoroughly to accelerate the process.

2. When defrosting is completed, clean your

freezer as described above.

AwARNING 
Do not use sharp objects to remove frost from the 

freezer compartment. Only after the interior is 

completely dry should the appliance be 

switched back on and plugged back into the 

main socket. 
Door gasket cleaning 
Take care to keep door gasket clean. Sticky food 

and drinks can cause gasket to stick to the 

cabinet and tear when you open the door. Wash 

gasket with a mild detergent and warm water. 

Rinse and dry it thoroughly after cleaning. 

A CAUTION 
Only after the door seals are completely dry 

should the appliance be powered on 

Replacing the LED light 

Warning: The LED light must be replaced by a 

competent person. If the LED light is damaged, 

follow the steps below: 

l. Unplug your appliance.

2. Remove light cover by rising up and pulling out

the LED light.

3. Hold the LED light with one hand and pull it wi佑

the other hand while pressing 佑e connector latch.

4. Replace LED light and snap it correctly in place

and recover the light cover.

1

5

Содержание H620BS-WD





















Отзывы: