Stand your appliance in a dry place to
avoid high moisture.
Keep the appliance out of direct
sunlight
，
rain or frost. Stand the
appliance away from heat sources
such as stoves, fires or heaters.
●
●
It may not work properly if being left at
a temperature above or below the
indicated range for a long period.
Installing
your
new
appliance
Before using the appliance for the first
time, you should be informed of the
following tips.
Ventilation
of
appliance
In order to improve efficiency
of the cooling system and
save energy, it is necessary to
maintain good ventilation around the
appliance for the dissipation of heat.
For this reason, sufficient clear space
should be available around the
refrigerator.
Suggest :
It is advisable for there to be
at least 75mm of space from the back
to the wall, at least 100mm from its
top,at last 100mm from its side to the
wall and a clear space in front to allow
the doors to open 135°. As shown in
following figures.
Note:
This appliance performs well within
the climate class from
showed
in the table below.
SN to T
●
Leveling of appliance
For sufficient leveling and air
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
To allow the door to self-close, tilt the
top backwards by about 10mm.
●
●
Installing the door handle
For the convenience of transportation,
the door handles are separately
provided in a plastic bag, you can
install the door handles as follows.
1. Lever the screw hole covers on the
side which you want to install the
handle of the door, and then put them
back to the plastic bag.
2. Take the handle match on the right
side of the door as the example,
keeping axes of screw holes in the
handle and the door in a line, as the
picture shows.
Symbol
Ambient Temperature
range
(
)
°C
SN
N
ST
T
+10 to +32
+16 to +32
+16 to +38
+16 to +43
Class
Extended
Temperate
Temperate
Subtropical
Tropical
8
10mm
≤
freezer door
screw hole cove
handle part
screw
handle cover
3. Fix the handle with the screws
provided in the plastic bag. And then
install the handle covers
.
as the above
figure shows
