
20
Vision Board WR6BE User Manual
Making Connections
Using an external interface with the touch screen and selection of the
touch unit
This device has a Touch port. When using an external PC as the touch unit and signal
source unit, connect USB ports of the device and PC with a USB cable (both ends are male
connections), connect the PC to the device with a signal cable (HDMI and DP cable), and
switch the signal source to that channel. At this time, the touch screen can be connected to the
corresponding unit, and the touch screen can be used to perform touch operations on the unit.
On the home page, the device is used as the touch unit. In HDMI, OPS and DP channels, the
device is used as the touch unit by default. When the external unit is connected and powered
on, and the USB cable is connected to the external unit (OPS does not need a USB cable), the
touch unit is changed to the external PC.
To operate the device, use the five-point touch method to call out the soft control menu and
operate the device. Afterwards, tap any area outside the soft control menu of the device to
hide the soft control menu. Then you can continue to operate the external PC, and the current
channel is set as the touch input channel.
Connecting to a Touch interface device
It is the touch screen interface used for an external PC. In both the HDMI and DP channels, the
device is used as a touch unit by default
When connecting, USB cables no longer than 1 meter should be used to connect with the
external PC.
Device port
TO
UCH
USB
PC
Connecting to a USB interface device
The total current of all the USB output ports of the device when connected to external devices
at the same time must not exceed 4800mA, or else the device failure caused by overcurrent is
not covered by the warranty.
NOTE
This device is connected to wireless keyboard and mouse devices. If there is any insensitivity
phenomenon during use, try changing the wireless receiver to another USB port, or using a
USB extension cord to connect the wireless receiver to enhance the receiving range.
External device
Device port
USB
DC 5V 0.5A(MAX)
USB
DC 5V 1A(MAX)
HEADPHONE
Connect headphones for audio out of the screen.
NOTE
Please make sure that the headphones are without microphone function, as it may not be
supported.
Headphones (not included)
ATTENTION
Excessive sound pressure from
earphones and headphones can
cause hearing loss.
HEADPHONE
Device port
Содержание 65WR6BE
Страница 1: ...Bar code...
Страница 20: ...17 Vision Board WR6BE User Manual Installation Guide...