HISEER VR2002, Установка, эксплуатация и обслуживание

Страница: 35 / 67

34
Changing Set Points
Display Procedures
In stop mode, press <Enter> for 2 seconds and release it to activate the Menu mode.
.
+
-
When the icon is blinking, press <Plus> or <Minus>
to navigate to the menu, and then press <Enter> to
proceed.
Contents under the Parameter Menu may vary with the privilege right of the user.
•
For end users, select “ NO ,” and press <Enter > to proceed.
•
For service men and factory users, select “ EU ” or ” ID ”, and press <Enter> to input the 4-digit
password .
.
+
-
For end users, parameters in the “ST” group will by
default be displayed.
Or, continuously press <Esc> to exit out of the current level and back to the desired menu level.
Accessing the Parameter Menu
Display Procedures
In Stop mode, press the <Enter> for 2 seconds and release it to activate the Menu mode.
When the icon is blinking, press <Plus> or <Minus> to navigate to the menu, and then
press <Enter> to proceed.
Contents under the menu may vary with the privilege right of the user.
•
For end users, select “ NO ” and press <Enter > to proceed.
•
For service men and factory users, select “ EU ” or “ ID ” and press <Enter>. Input the 4-digit
password when the following screen is displayed
.
+
-
Press <Enter> to confirm and continue to input the
password.
.
+
-
Password is required for the service man (EU) and
factory users (ID).
To input password, follow the instructions below:
•
When the digit is blinking, press <Plus>/<Minus> to select the value. Then, press <Enter> to
confirm, and proceed to the next digit.
•
Or, press <Esc> at any time to cancel the input and return to the previous blinking digit.
•
Repeat steps above to input other three numbers.
•
After inputting the password, press <Enter> to confirm, and proceed to the setting parameter
values.
Controller