Safety and Regulatory Information
4
UM19.5A User Manual, 99159, March 2017
Waste Electrical and Electronic Equipment Directive (WEEE)
The following information is only for EU-member states:
The mark shown to the right is in compliance with the Waste Electrical and
Electronic Equipment Directive 2002/96/EC (WEEE)�
The mark indicates the requirement NOT to dispose of the equipment as unsorted
municipal waste, but use the return and collection systems according to local law. Users
should contact their supplier and check the terms and conditions of the purchase contract�
When purchased directly from Hope Industrial Systems, you may contact technical support
for disposal arrangements.
Hazardous Locations
The following applies only to monitors rated for hazardous locations (model
numbers HIS-UM19.5- _ _ HA and HIS-UM19.5- _ _ UA):
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, and D; Class II,
Division 2, Groups F and G; Class III; or non-hazardous locations only�
WARNING – EXPLOSION HAZARD – Do not disconnect equipment unless power has
been removed or the area is known to be non-hazardous�
WARNING – EXPLOSION HAZARD – Substitution of any components may impair
suitability for Class I, II & III, Division 2 Locations�
NOTE: Hope Industrial Systems provides wiring and conduit that complies with the U.S.
National Electric Code but cannot rate wiring or conduit methods for hazardous locations,
as these must be locally inspected and approved� The customer must install their
hazardous location rated monitor in accordance with the applicable electrical codes for
their location�
YB, PED4X4, and FPED series are not approved for routing internal cables in Class II or
III locations. If these mounting options are desired, customer must route cables outside of
pedestal�
Choose only CP-CON-xx or CP-BLNK-xx cover plate series for Universal Mount Monitors
for hazardous locations�
