Installation GREYHOUND Switch
Release 01 04/2016
43
Mounting in a switch cabinet
Note:
When operating the device in an environment with continuous
vibration loads of greater than 0.7 g, you must additionally fasten the
device to the switch cabinet using 2 holding brackets on the front and
back of the device.
You obtain the additional brackets as accessories.
See “Accessories” on page 71.
Prerequisites:
Install the device in the 19" switch cabinet using sliding or mounting
rails.
This provides a more stable position of your device in environments
subject to vibration.
For more information on sliding/mounting rails and how to install them,
please contact your switch cabinet manufacturer.
The devices are designed to be mounted in a 19" switch cabinet.
In the delivery state, there are 2 pre-mounted holding brackets on the
sides of the device.
Verify that there is sufficient ventilation. If required, install a fan to keep
the device from overheating.
Measure the depth of the 19" cabinet so that all the lines to be
connected can be fed in easily.
Proceed as follows:
Assemble the sliding or mounting rails in the 19" switch cabinet as
specified by the manufacturer.
Position the device on the rails in the switch cabinet.
Fasten the device by screwing the brackets to the switch cabinet.
The tightening torque is 4.4 lb-in (0.5 Nm).
