HIOTH
User Manual
HIOTH TECHNOLOGY CO.,LTD.
5)
If the device can still be displayed (network exclusion failed), repeat steps 2-4.
NOTE:
If the device is online, directly perform steps 1-5, if the device is offline, need
interruption of the device power supply first, and then perform step 1-5.
MOTION DETECTOR RESET
Reset procedure clears the modules’ EPROM memory, including all information
about the Z-Wave network controller, calibration and power consumption data.
1)
Make sure the device is connected to the power supply.
2)
Pressing link key 3 times within 1.5 second (Detector beeps when link key is pressed
.
).
3)
Within 1 second, press and hold the link key until beep stops (A long beep is sounded for 5
seconds).
4)
IDs are excluded and all of preset value will be reset to factory default (2-second on, 2-second
off).
Installation Instructions
It’s recommended to install the Motion Detector on a wall or under a ceiling.
MOTION DETECTOR INSTALLATION
1)
Undo and remove the screw from the bottom edge of the detector to detach the rear cover
(Fig.2).
Fig.2
2)
Unscrew the screw from the battery cover and remove the battery cover.
