HIOTH
User Manual
HIOTH TECHNOLOGY CO.,LTD.
⑤
Link Key
Fig.1
Z-WAVE NETWORK INCLUSION
In the rear casing, there is a link key which is used to carry out inclusion, exclusion, association
or reset. When the detector is first powered up, the LED flashes on and off alternately and repeate
dly at 2-second intervals. It implies that it has not been assigned a node ID and cannot work with
Z-Wave enabled devices.
1)
Connect the power supply, and make sure that device in a state of "No node ID" (2-second
on, 2-second off).
2)
Choose "Z-Wave" to enter the Network Inclusion mode on the APP, then click "
".
3)
Pressing link key 3 times within 1.5 second (Detector beeps when link key is pressed
.
).
4)
When prompt a message “Request Access Success”, please go to the device list interface, and
refresh the device list, the device will be displayed.
Z-WAVE NETWORK EXCLUSION
1)
Make sure the device is connected to the power supply.
2)
Remove the device on the APP, then click "finish".
3)
Pressing link key 3 times within 1.5 second (Detector beeps when link key is pressed
.
).
4)
Please go to the device list interface, and refresh the device list, the device will not be
displayed.
