1
6.35
9.0
・
6.35mm hexagon shape
・
The length from the end of bit
to center of the ditch is 9mm
(Bit with double ditches)
Proper Bit type
Improper Bit type
(Double end Bit)
More than 9.0
4. Avoid any location that is wet, moist or oily.
Never use the screwdriver in the place where there is a lot of dust, debris, oil or corrosive gas.
Otherwise an electric shock or damage might be caused in the place with high humidity in particular.
5. Please use the screwdriver carefully due to avoid drop off.
6. Before changing rotation way from Forward to Reverse, please make motor to be stopped by sliding FOR/REV
switch to OFF (Neutral position).
7. Please note the following about carbon brushes.
(1) The range of use is up to the position of the groove on the brush surface. (
🅐
)
When it wears to the specified position, replace it with a new one.
(2) When replacing the carbon brush, replace the two places with new ones at the
same time. (
🅑
)
・
When replacing, set the brush surface in the direction that matches the internally
rotating commuter surface.
・
Be careful not to overtighten the carbon brush cap.
(3) In order to prevent the insulation from being deteriorated due to the wear
powder of the carbon brush, be sure to send the screwdriver for maintenance and
inspection 1 million times or after 1 year of use.
(4) Please use genuine HIOS products.
Do not use carbon brushes of different dimensions or made by other companies. It may cause a malfunction.
Please note that we are not responsible for any accidents or malfunctions caused by using parts other than
those specified.
<Usage Procedure>
1. The way of driver grip can be adjustable after take off 3pcs of hexagon
socket set screws from the arm holder.
After adjusting of the grip position or the way of slide arm, please fix it
again with hexagon socket set screws.
2. Please hold the stand base at 3points by bolts.
Make sure it to be hold firmly to withstand large shock.
3. Set up the height of the slide arm.
Put the prop through the shock-less holder and tighten the wing bolt
at the demanding height of the slide arm to hold.
*NOTE: Each set screws are sometimes loosen due to tightening shock.
Please check them periodically.
🅐
🅑
Arm Holder
Hexagon socket set screw
