- 7 -
◆ Adjustment of the passage plate
Check the height of the passage plate.
•
Ensure that the passage plate is adjusted at a height where the used
screw can manage to pass.
•
If the passage plate is too low, the screw cannot pass, and if too
high, the screw easily gets caught.
•
If adjustment is necessary, adjust it by loosening the passage plate
attaching screw.
Caution
: Slide the half blanking at both sides of the passage plate up
and down the guide.
◆ Adjustment of the rail
Check the physical relationship of the stopper and sensor.
•
ensure that the rail is fixed so that “
A
” portion of the stopper is 0 mm
to 0.5 mm ahead of the sensor optical axis.
•
If adjustment is necessary, adjust the location by loosening the rail
attaching screw.
Ensure the screw passes
through the window with no
extra space.
Screw
Passage plate
Passage plate attaching screw
Halfway hole
(On both sides of the passage
plate)
Looking down from the top, a portion of the stopper is
sticking out 0 to 0.5 mm more forward than the sensor's
optical axis. (It's not necessary to remove the bit guide.)
Adjust the rail back and forth.
A
Loosen the rail attaching screw.
