HIOS HDP-100, Руководство по эксплуатации, Страница: 3 / 16

Safety Precautions
■
Before using
•
Before you begin using the instrument, read the
operating instructions and also the precautions
given on the seal affixed to the instrument.
•
The torque meter's display unit and sensor unit
come with the same serial number. These two
parts of the instrument are calibrated together;
do not use any different combination.
•
HIOS cannot assume responsibility for ac-
cidents or difficulties when the instrument has
been remodeled or disassembled, or when it has
been used in a way other than that explained in
the operating instructions.
■
During operation
•
Be sure to attach the bit securely into the sensor
unit chuck.
•
For safety, make sure the bit never points at
anything other than the tool to be measured.
•
When using the support arm that comes with
Model HDP-50, be sure to attach it securely to
prevent it from coming loose under high torque
loads.
•
To avoid damaging the sensor unit, do not sub-
ject it to rough handling.
•
If the torque meter shows any functioning ab-
normality, cease operation immediately and
contact HIOS Corporation or your HIOS dealer.
•
Operators of power tools should always button
cuffs and shirt fronts and fasten zippers on ap-
parel when conducting operations.
•
Operators of power tools should not wear gloves,
as this interferes dangerously with having a
proper grip on the tools.
■
Precautions in operating a digital
torque meter
•
Never exceed the maximum torque levels indi-
cated in the specifications on page 10. Exceed -
ing capacity load levels by 120% will result in
internal damage to the meter.
•
The battery charger is for NiMH batteries only. Nev-
er use any other kind of battery, even from HIOS.
•
Do not disassemble the instrument or loosen the
screws on its body, as this could cause inaccu-
racy in measurement.
•
Protect the display and sensor units from shocks
or impacts.
•
Always detach the bit from the sensor unit after
use.
•
Use of the battery charger
See page 8 for instructions on battery charging.
•
Use only the products specified in these operat -
ing instructions for connection to the data out-
put ports.
•
When disconnecting cables, grasp the cable plug
and take care not to damage connector pins.
•
Always turn the power switch off after complet-
ing measurement operations.
•
Do not strike the acrylic display panel or place
heavy objects on it.
•
Avoid excessive internal adjustments for calibrat-
ing or other purposes.
•
Handle the instrument with care and take care
not to drop it.
• This instrument is sensitive to ambient condi-
tions. Avoid using it in the following kinds of
places:
•
Places where water, oil or other liquids could
fall onto or get inside the instrument.
•
Places subject to vibration, dust or hot air.
•
Outdoors, or places where electrical discharges
may occur.
•
Places of high temperature or humidity. (Operat-
ing humidity and temperature ranges for digital
torque meters are 25% − 65% and 15
℃
− 35
℃
).
•
Any other place where there is a danger of the
instrument being damaged or its functioning
impaired.
•
Please do not store the instrument in places of
high temperature or high humidity. This could
result in condensation forming inside, which
could endanger functioning.
Please read the following safety precautions
to ensure safe and correct operation.
- 2 -