Please note: On gasoline engine platform when the engine is cold, pre-heat it
pressing the “PREHEAT” button on the remote control, engine will run faster for
20 seconds.
MOVING THE TRACKS
To move the tracks it’s necessary that all the outriggers are raised from the
ground. It’s possible to move the tracks even if jib arm (last arm, see picture
below) is opened but in this case basket should be empty, therefore the
operator must be at the ground keeping the remote control on his hands.
Otherwise when jib arm is closed the tracks could be moved operating from the
basket.
To move the tracks (with all the outriggers raised from the ground) press the
tracks red joystick on the remote control. To open the jib arm press the jib
movement joystick. Jib should be closed to allow outriggers movements
ALIGNMENT
ARROWS
TRACKS SPEED COULD BE
LIMITATED BY AN AUTOMATIC
SPEED CONTROL THAT PREVENT
UNSAFE TRANSALTION
CONDITIONS
TRANSLATION WITH JIB OPENED
IS POSSIBLE ONLY WHEN
OPERATOR AT THE GROUND
TRANSLATION WITH JIB CLOSED
IS POSSIBLE FROM THE GROUND
OR FROM THE BASKET.
JIB ARM
OPENED
MOVING THE OUTRIGGERS
To move the outriggers it’s necessary that
the machine is perfectly closed and aligned
(all the arms and the jib closed). In this
case the display shows the MACHINE
CLOSED AND ALIGNED icon (see the
picture below). To move the outriggers the
remote control could be in the basket
support or the operator can keep it in his
hands also standing on the ground.
MACHINE CLOSED
AND ALIGNED ICON
ON THE DISPLAY
PHOTOCELLS SYSTEM
DETECTS THE CLOSE AND
ALIGNED CONDITION OF
THE MACHINE