HM360 DSC MAX
12
DW/Triw key (Dual Watch/Tri Watch)
At the normal mode, short press DW/TRIW key to activate
the DUAL WATCH mode. Monitor the current channel
and Ch 16 in cycle. Whenever, Weather Alert is activated,
the Wx Alert channel will be monitored once every 4sec.
Long press DW/TRI key to activate the TRI WATCH mode.
Monitor the Ch 16, current channel and 1 programmed
channels in cycle.
Torch/R/W
The torch can work at two color :red and white.Short press
the Torch/R/W key will switch the torch on or off, If
quickly short press the Torch/R/W key, the torch will
sequence produces this phenomenon: no flash,fastly
flash,slowly flash (SOS) the led. Long press the Torch/R/W
key will toggle red color torch or white color torch.
Backlight
Any key press will turn on the backlit (if backlit setting is
ON ) except the PTT key. The backlit should be remaining
on for 5 seconds if no any keys pressed. The time out will
be reset if any key pressed within the time frame.
Quake Water
To activate Quake Water press and hold the SCAN key
whilst switching on the HM360 DSC MAX. You will be
prompted with a beep tone and the letter‘Shock Wave Short
Press the SCAN to run it ’will display. Press SCAN to
activate Quake Wate and hold the HM360 DSC MAX face
down. After the water completely kick off from the speaker
grids,short press the 'SCAN 'key to stop the Quake Wate
feature. Then reset the HM360 DSC MAX again.
Other features and solutions
Special function keys
If you press the call/menu key
and power key then you can
enter the up grade mode directly
Press the DW/TRW key and
the power key
，
then you can
enter the writing channel mode
Directly
TX Time Out
The transmission will be automatically turn off after PTT
key pressed over 5 consecutive minutes. The TX mode will
be terminate and back to Rx mode. To indicate the PTT key
as the stuck condition. Once the PTT key is released, the
TX time out timer will be reset. PTT key will work back
normally.
WDT–Water Displacement Technology
To activate WDT press and hold the SCAN key whilst
switching on the HM360 DSC MAX. You will be
prompted with a beep tone and the letter‘Shock Wave Short
Press the SCAN to run it ’will display. Press SCAN to
activate WDT and hold the HM360 DSC MAX face down.
After the water completely kick off from the speaker
grids,short press the 'SCAN 'key to stop the WDT feature.
Then reset the HM360 DSC MAX again.
Build in Battery
The HM360 DSC MAX model has the Build in Battery
design likes the iphone there are three steps to installation
and removal the battery in below diagram.
Step1
Step2
Step3
The software’s
Upgrading by PC
Please wait----
The Private
Channels are
Cloning by PC
Please wait----
