HIMA HIMax X-CPU 01, Руководство пользователя

Страница: 23 / 52

X-CPU 01 3 Product Description
HI 801 009 E Rev. 4.00 Page 23 of 52
Overview of Switch Positions
Module behavior if the module starts after switching on the operating voltage or after a fault:
Switch Position Only individual processor
module Additional processor
module (redundant
operation)
Init Enters the LOCKED state with the factory settings
Switch from Init to Stop Enters the STOP state
Switch from Init to Run
Starts operation, if the Autostart
system parameter is set to
TRUE
Init: Command from PADT
ƒ System operation
ƒ Cold Start
Enters RUN state (mono
operation)
Stop Enters the STOP state
Run Executes the user programs.
Starts redundant operation
Table 12: Overview of the Mode Switch Positions
3.4.19 Monitoring the Operating Voltage
The HIMax processor module monitors its supply voltages L1+/L1-, L2+/L2-. The following
applies for each supply voltage:
Voltage level Voltage status
< approx. 18 V supply voltage faulty
otherwise Supply voltage OK
Table 13: Supply Voltage Status
NOTE
Controller damage due to excessively high operating voltage!
Do not connect supply voltage exceeding 30 volts
3.4.20 Monitoring the Temperature
Sensors continuously monitor the operating temperature of the modules.
The temperature status of a processor module indicates wether the temperature thresholds
have been exceeded with respect to the following environment temperature ranges:
Temperature range (approx.) Temperature status
< 40 °C Temperature OK
40...60 °C Temperature threshold 1 exceeded
> 60 °C Temperature threshold 2 exceeded
Table 14: Temperature Status
If the temperature exceeds a specific threshold or falls below it, the temperature status
changes.
Table 14 applies to normal operation with operating fans. In case of abnormal operation,
e.g., without fans, the temperature status can indicate that the temperature thresholds have
been exceeded even at a lower environment temperature.
The temperature status is a status of the processor module. After logging in to the
processor module, the module status is displayed in the SILworX Control Panel.