Hilti WSC 7.25-S, Оригинальная инструкция по эксплуатации

Страница: 12 / 46

6 English 322275
*322275*
WSC 7.25­S
Saw blade diameter 184 mm
(7.2 in)
Saw blade disc thickness
1.1 mm … 1.5 mm
(0.04 in … 0.06 in)
Kerf width 1.7 mm … 2.3 mm
(0.07 in … 0.09 in)
Saw blade arbor size
5/8 in
Cutting depth at 0° 0 mm … 62.5 mm
(0 in … 2.46 in)
Cutting depth at 45° 0 mm … 43.5 mm
(0 in … 1.71 in)
Cutting depth at 56° 0 mm … 32.5 mm
(0 in … 1.28 in)
No-load speed 5,800 /min
Protection class II
5 Use of extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶
Check the appliance’s supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate
cross-section. Otherwise the performance of the appliance may be affected and the cord may overheat.
• Regularly check the extension cord for damage.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Recommended minimum conductor gauge (cross section) and maximum cable length with 120V
supply voltage
Extension cables AWG 16 AWG 14 AWG 12 AWG 10
Extension cable conductor gauge 1,31 mm² 2,08 mm² 3,31 mm² 5,26 mm²
Extension cable conductor gauge 2,58 kcmil 4,11 kcmil 6,53 kcmil 10,4 kcmil
Extension cable length 25 m 30 m 50 m 100 m
Extension cable length 75 ft 100 ft 150 ft 250 ft
6 Operation
6.1 Removing the saw blade 3
WARNING
Risk of burning injury. A hot accessory tool, clamping flange or clamping screw and the sharp edges of the
saw blade present hazards.
▶
Wear protective gloves when changing saw blades.
1. Disconnect the supply cord plug from the power outlet.
2. Press the arbor lockbutton.
3. Turn the saw blade clamping screw with the hex key until the arbor lockbutton engages fully.
4. Use the hex key to slacken the clamping screw by turning it counter-clockwise.
5. Remove the clamping screw from the outer clamping flange.
6. Open the pivoting guard by swinging it clear and remove the saw blade.
Printed: 11.09.2018 | Doc-Nr: PUB / 5071331 / 000 / 04