Hilti TE 500-AVR, Оригинальная инструкция по эксплуатации

Страница: 15 / 84

*2146361*
2146361 English 9
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault Possible cause Action to be taken
The breaker doesn’t start. Interruption in the electric supply.
▶
Plug in another electric tool or
appliance and check whether it
works.
The electronic restart interlock is
activated after an interruption in
the electric supply.
▶
Switch the power tool off and
then on again.
The generator is in sleep mode.
▶
Apply a load to the generator
by connecting a second power
consumer (e.g. worklight).
Switch the tool off and then on
again.
A fault has occurred in the tool.
▶
Have the product repaired by
Hilti Service.
The carbon brushes are worn.
▶
Have checked by a trained elec-
trical specialist and replaced if
necessary.
No hammering action. The power tool is too cold.
▶
Bring the tip of the accessory
tool into contact with the
working surface, switch the
power tool on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
The breaker doesn’t achieve
full power.
The extension cord is too long or
its gauge is inadequate.
▶
Use an extension cord of an
approved length and / or of
adequate gauge.
The control switch is not fully
pressed.
▶
Press the control switch as far
as it will go.
The chisel cannot be released
from the chuck.
The chuck is not pulled back fully.
▶
Pull the chuck back as far as
it will go and remove the insert
tool.
The service indicator blinks. A fault has occurred in the tool.
▶
Have the product repaired by
Hilti Service.
The service indicator lights. The carbon brushes are worn.
▶
Have checked by a trained elec-
trical specialist and replaced if
necessary.
The tool is faulty or servicing is
due.
▶
Have the product repaired only
by Hilti Service.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶
Do not dispose of power tools, electronic equipment or batteries as household waste!