5
en
The tool is designed for use on construction sites where
the above types of work are carried out.
The tool may be operated only when connected to a
power supply providing a voltage and frequency in
compliance with the information given on its rating
plate.
Changes or modifications to the tool are not permis-
sible.
Do not use the tool for mixing (with a mixing paddle).
Use only the drill bits and screwdriving bits intended
for use with this tool.
Observe the information printed in the operating instruc-
tions concerning operation, care and maintenance.
The tool and its ancillary equipment may present haz-
ards when used incorrectly by untrained personnel or
when used not as directed.
4.2 Chuck
– Quick-release chuck or
– Key-type chuck with key
4.3 Switches
– On/off switch with electronic speed control
– Lockbutton for sustained operation
– 2-speed gear selector switch
– Forward/reverse pushbutton
4.4 Grips
– Adjustable (pivoting) side handle with depth gauge
– Vibration-absorbing grip
4.5 Items supplied as standard
– The electric tool
– Side handle
– Depth gauge
– Chuck (quick-release chuck or key-type chuck with
key)
– Operating instructions
– Toolbox or cardboard box (depending on version)
See figure
and the explanations of operating controls
and parts on page 1.
5. Technical data
Tool
Rated power input
Rated voltage
Rated current
Mains frequency
Weight of tool
Dimensions (L x W x H)
Speed under no load
Chuck
Max. torque
Speed control
Forward/reverse
Double insulated
Vibration absorbing grip and side handle
Interference immunity
Right of technical changes reserved!
SR 16
600 W
120 V
5.8 A
50–60 Hz
4.4 lb (2.0 kg)
11.6
×
7.7
×
2.8 in (295
×
195
×
72 mm)
1
st
gear 0–750 r.p.m.
2
nd
gear 0–1900 r.p.m.
1
/
24
–
1
/
2
" (1–13 mm) dia.
1
st
gear 50 Nm
2
nd
gear 20 Nm
Electronic control switch (on/off switch)
Pushbutton, interlock prevents switching when running
Protection class II
Z
6. Assembly
6.1 Fitting the side handle
-NOTE-
The side handle can be removed only when the quick-
release chuck is used. The side handle cannot be remo-
ved from the tool when the key-type chuck is in use.
1. Release the side handle clamping band by turning
the handle in a counter-clockwise direction.
2. Fit the side handle clamping band over the chuck
and onto the cylindrical section at the front end of
the tool.
3. Pivot the side handle into the desired position.
4. Secure the side handle by turning the handle in a
clockwise direction.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070702 / 000 / 00