Hilti SPN 6--A22, Оригинальная инструкция по эксплуатации, Страница: 27 / 192

*2253586*
2253586 English 21
5. When you reach the end of the cut, switch the product off. If the line of cut ends in the workpiece, with
the product still switched on pull it a few millimeters back along the line of the cut before switching it off.
Do not lay the nibbler down in the swarf before it has come to a complete stop. Pieces of swarf
could be sucked in by the motor.
6.3 Cutting with template 6
Option: SPN­CN
The requirements for cutting with a template are as follows:
• The template must be 5 ­ 7 mm thick.
• The contour of the template must be 2.5 mm distant from the contour of the cut.
• Note that the minimum radius is 4 mm. Accordingly, the minimum radius of the template is 6.5 mm.
• Guide the nibbler in such a way that the outside edge of the punch guide is always in contact with the
template.
6.4 Switching off
▶
Press the rear section of the on/off switch.
➥ The on/off switch jumps into the off position and the motor stops.
7 Optional accessories
7.1 Installing the swarf bag 7
Option: SPN­CN
A swarf bag can be installed to catch the pieces of swarf produced by the cutting operation so that they
cannot scatter.
1. Squeeze the two ends of the spring in the swarf bag together.
2. Hook the spring round the bottom end of the die and release the ends of the spring.
3. Check that the spring and the swarf bag are correctly seated and secure.
8 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶
Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove any dirt that may be adhering to parts.
• Remove the dust filter and clean it and the air vents carefully, using a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the lithium­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.