Hilti SIW 18T-A, Руководство по эксплуатации, Страница: 19 / 24

en
11
5 Before use
5.1 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean and dry before
inserting the battery in the corresponding charger.
Read the operating instructions for the charger for further information about
the charging procedure.
5.2 Inserting the battery 2
CAUTION
Before fitting the battery, check that the power tool is switched off and
that the safety lock is engaged (forward/reverse switch in the middle
position).
CAUTION
Before inserting the battery in the power tool, check to ensure that
the battery terminals and the contacts in the power tool are free from
foreign objects.
1. CAUTION A falling battery may present a risk of injury to yourself
and others.
Check that the battery is securely seated in the tool.
5.3 Removing the battery 3
5.4 Transport and storage of batteries
Pull the battery out of the locked position (working position) and move it into
the first latching position (transport position).
Observe national and international transport regulations when shipping
batteries (transportation by road, rail, sea or air).
6 Operation
6.1 Changing sockets
6.1.1 Changing the socket (½" square drive with ball-notch reten-
tion)
NOTE
Bring the notch in the socket into alignment with the ball on the square drive
before fitting it to the power tool. The socket will not be held securely and
could fall off inadvertently if this point is not observed.
Printed: 20.05.2015 | Doc-Nr: PUB / 5136087 / 000 / 03