Hilti SIW 18T-A, Руководство по эксплуатации, Страница: 17 / 24

en
9
NOTE
Approved accessories are available from your Hilti Center or can be ordered
online at www.hilti.com .
3.3 Additional items required for operating the tool
A suitable battery of the specified type (see table in the Technical Data
section) and a suitable battery charger from the C 4⁄36 series.
3.4 Charge state and overheating indicator display on the Li-ion bat-
tery
When the lithium-ion battery is in use, the charge status can be indicated
by gently pressing one of the battery release buttons (press until resistance
is felt – do not release the battery). The display on the rear of the battery
provides the following information:
LEDs light constantly LEDs blink Charge status C
LED 1, 2, 3, 4 - C ≧ 75 %
LED 1, 2, 3 - 50 % ≦ C < 75 %
LED 1, 2 - 25 % ≦ C < 50 %
LED 1 - 10 % ≦ C < 25 %
- LED 1 C < 10 %
- LED 1 The battery has over-
heated
NOTE
Indication of the charge status is not possible while the power tool is in
operation or immediately after operation. If the battery charge status LEDs
flash, please refer to the information given in the Troubleshooting section.
3.5 Power tool overloading and overheating indicator
The power tool is equipped with an electronic protection system to prevent
overloading and overheating. The power tool switches itself off automatically
in the event of overloading and overheating. After releasing the control
switch, the power tool may not restart immediately when the switch is
pressed again (while the power tool is cooling down).
LEDs light constantly LEDs blink Power tool status
- LED 1, 2, 3, 4 Power tool over-
loaded or over-
heated
Printed: 20.05.2015 | Doc-Nr: PUB / 5136087 / 000 / 03