14 English
▽
is shown in the display (code could not be read or was not
recognized).
▶
Press the scan button and scan the code again.
Note
It is possible that operating parameters for the product to be
tightened are not yet available from the torque module memory.
If a QR code marked with "SIAT ready" exists for the product,
please scan this code as this also contains the necessary
tightening parameters and the data scanned will then be saved
in the torque module memory. The tightening parameters for the
product can also be uploaded via USB to the torque module by
using the
PROFIS Adaptive Torque
PC application. Regularly
check for updates to the software installed in the torque module
in order to ensure that the latest parameters are always applied.
SIAT ready QR codes, if they exist for the product, can be found
on the packaging, in the instructions for use of the product or
online in the download area for the applicable product at the
Hilti
website.
4. Lock the torque module. → page 6
5.8 Tightening the bolted connection in “Adaptive” operating mode
Note
Before using the torque module, check to ensure that the product to be
tightened is installed correctly. Observe the information and instructions
concerning checking bolted connections.
1. Set the tool to “Adaptive” operating mode.
2. Set the forward/reverse switch to the “forward” position.
3. Fit a suitable accessory tool (e.g. socket) to the impact wrench and then
bring it into position on the product to be tightened.
4. Press the control switch and hold it in this position until the torque module
emits one of the following signal tones (Note: the tone generator may
deactivated).
Printed: 15.09.2017 | Doc-Nr: PUB / 5331629 / 000 / 02
Содержание SI-AT-A22
