Hilti SFE 2-A12, Оригинальная инструкция по эксплуатации

Страница: 18 / 36

14 English
▶
Never transport batteries in bulk form (loose, unprotected).
▶
Check the tool and batteries for damage before use after long periods of
transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the tool and batteries in a place that is as cool and dry as possible.
▶
Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶
Store the tool and batteries in a place where they cannot be accessed by
children or unauthorized persons.
▶
Check the tool and batteries for damage before use after long periods of
storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
9.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The power tool does
not work.
The battery is not fully
inserted.
▶
Push the battery in
until it engages with
an audible click.
The control switch
cannot be pressed,
or is stuck.
The forward/reverse
switch is in the middle
position.
▶
Push the
forward/reverse
switch to the left or
right.
Running speed sud-
denly drops consid-
erably.
Low battery.
▶
Change the battery
and charge the empty
battery.
The battery runs
down more quickly
than usual.
Very low ambient tem-
perature.
▶
Allow the battery to
warm up slowly to
room temperature.
The battery doesn’t
engage with an audi-
ble click.
The retaining lugs on the
battery are dirty.
▶
Clean the retaining
lugs and engage the
battery in the working
position.