Hilti SFE 2-A12, Оригинальная инструкция по эксплуатации

Страница: 10 / 36

6 English
▶
Do not expose a battery pack or tool to fire or excessive temperature.
Exposure to fire or temperature above 130° C (265 °F) may cause
explosion.
▶
Follow all charging instructions and do not charge the battery pack
or tool outside the temperature range specified in the instructions.
Charging improperly or at temperatures outside the specified range may
damage the battery and increase the risk of fire.
Service
▶
Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
▶
Never service damaged battery packs. Service of battery packs should
only be performed by the manufacturer or authorized service providers.
2.2 Drill safety warnings
Safety instructions for all operations
▶
Hold the power tool by insulated gripping surfaces, when performing
an operation where the cutting accessory or fasteners may contact
hidden wiring. Cutting accessory or fasteners contacting a "live" wire
may make exposed metal parts of the power tool "live" and could give
the operator an electric shock.
Safety instructions when using long drill bits
▶
Never operate at higher speed than the maximum speed rating of the
drill bit. At higher speeds, the bit is likely to bend if allowed to rotate
freely without contacting the workpiece, resulting in personal injury.
▶
Always start drilling at low speed and with the bit tip in contact with
the workpiece. At higher speeds, the bit is likely to bend if allowed to
rotate freely without contacting the workpiece, resulting in personal injury.
▶
Apply pressure only in direct line with the bit and do not apply
excessive pressure. Bits can bend causing breakage or loss of control,
resulting in personal injury.
2.3 Careful handling and use of batteries
▶
Observe the special guidelines applicable to the transport, storage and
use of lithium-ion batteries.
▶
Do not expose batteries to high temperatures, direct sunlight or fire.
▶
Do not disassemble, crush or incinerate batteries and do not subject them
to temperatures over 80 °C (176 °F).
▶
Do not use or charge batteries that have suffered mechanical impact,
have been dropped from a height or show signs of damage. In this case,
always contact your Hilti Service .
▶
If the battery is too hot to touch it may be defective. Put the battery in
a place where it is clearly visible and where there is no risk of fire, at an
adequate distance from flammable materials. Allow the battery to cool