Hilti SF BT 22-A, Оригинальная инструкция по эксплуатации

Страница: 17 / 44

*2160456*
2160456 English 11
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The battery doesn’t
engage with an audi-
ble double click.
The retaining lugs on the
battery are dirty.
▶
Clean the retaining
lugs and push the
battery in until it
engages. Contact
Hilti Service if the
problem persists.
The control switch
can’t be pressed, i.e.
the switch is locked.
The safety lock is en-
gaged.
▶
Push the switch safety
lock to the side (to the
left as seen from the
working direction).
The power tool
doesn’t run.
The battery is not fully
inserted.
▶
Push the battery in
until it engages with
an audible click.
The tool doesn’t
work and one LED
blinks.
Low battery.
▶
Change the battery
and charge the empty
battery.
The tool cuts out
while operating, the
4 LEDs on the bat-
tery display blink.
The overload cut-out
has been activated.
▶
Release the control
switch and then press
it again.
The overheating cut-out
has been activated.
▶
Allow the power tool
to cool down. Clean
the air vents.
The battery runs
down more quickly
than usual.
Very low ambient tem-
perature.
▶
Allow the battery to
warm up slowly to
room temperature.
The tool or battery
gets very hot.
The tool is overloaded
(application limits ex-
ceeded).
▶
Pay attention to the
power and perfor-
mance rating of the
product before using
it, i.e check its suit-
ability for the job on
hand. See “Technical
data” section.
9 Manufacturer’s warranty
▶
Please contact your local Hilti representative if you have questions about
the warranty conditions.