Hilti PS200 Ferroscan, Руководство по эксплуатации, Страница: 46 / 315

6.2 PSA 91/PSA 94 memory card
Insert the memory card in the slot provided on the back
of the monitor.
To remove the memory card, press it once. The card will
release from the slot. It can now be easily gripped and
removed.
-WARNING-
Although the memory card is of the SD or Multimedia
Card type, standards vary between different manufac-
turers. To help ensure data security and integrity, mem-
ory cards supplied by Hilti should be used. Data may be
irretrievably lost if memory cards other than those sup-
plied by Hilti are used.
-WARNING-
Do not remove the memory card during operation or
when the monitor is switched on. Removing the card at
such a time may result in data loss. Only remove the
card when the monitor is switched off.
-NOTE-
When the memory card is removed, the monitor will auto-
matically revert to using the 3 MB internal memory. Data
will then be saved in this memory under a project with
the name "Prj00001" until a memory card is inserted in
the monitor. When a memory card is inserted and the
monitor switched on, all data in internal memory will be
transferred to the memory card automatically.
6.2.1 Using memory cards
With monitors with item no. 319281, only memory cards
of the MMC type may be used (up to a max. capacity of
128 MB). With monitors with item no. 31225, memory
cards of the MMC and SD types may be used (up to a
max. capacity of 1 GB).
-WARNING-
SD memory cards cannot be used with the old-type
monitor.
-NOTE-
The item no. can be found on the type identification plate
on the underside of the monitor.
44
en
6. Operation
6.1 PSA 80 battery
Charge both batteries using the PUA 80 chargers. Full
instructions are contained in the PUA 80 charger oper-
ating instructions. Before first use, the batteries must
be charged for 14 hours continuously.
6.1.1 Inserting and removing the battery
Check that the battery is correctly aligned with the scan-
ner or monitor as shown below.
Scanner – With the battery end cap facing you, the large
groove on the battery should be on the left.
Monitor – With the battery end cap facing you, the large
groove on the battery should be on the right.
Push the battery into the opening as far as it will go. Turn
the end cap clockwise until it slots into place and snaps
tight. To remove the battery, turn the end cap anti-clock-
wise as far as it will go. Withdraw the battery from the
scanner or monitor.
-CAUTION-
The battery should slide easily into the scanner or mon-
itor. Do not force the battery into the scanner or moni-
tor as this may damage the battery itself or the scanner
or monitor casing.
-WARNING-
Do not remove the battery during operation or when the
monitor is switched on. Removing the battery at such
a time may result in data loss. Remove the battery only
when the monitor is switched off.
PS
20
0
Fer
ros
can
-CAUTION-
Take care to ensure that
the card is inserted the
right way round.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070389 / 000 / 00