Hilti PP10, Руководство пользователя

Страница: 21 / 104

17
5.16 Setting and activating the security code
1. Press the on / off button and the lock button at the same time.
Note
Unauthorized persons can be prevented from using the laser tool by entering a 4-digit security code.
The user will be automatically requested to enter the code after the tool is switched on.
Please note that once the security code has been activated, the laser tool can no longer be
operated without entering this code.
2. Use the up / down buttons to move to the “Input S code” line.
3. Press the Set button to enter the correct mode.
4. Use the direction buttons and the up / down arrow buttons to navigate to the corresponding digit and
then press the Set button to confirm. Select four digits in this way and confirm the code by pressing the
Set button.
◁
The tool then returns to the previous mode.
5. The security code can be activated or deactivated by using the Set button to switch between on or off.
◁
The tool then returns to the normal operating mode.
5.17 Entering the name of the company
1. Press the on / off button and the lock button at the same time.
◁
The set values are shown in the display.
2. Use the up / down arrow buttons to navigate to the “Change name” line and then press the Set button
to select the mode.
3. Use the direction buttons and the up / down arrow buttons to navigate to the corresponding character
and then press the Set button to confirm. Press the Set button to confirm the name.
◁
The tool then returns to the normal operating mode.
5.18 Checking accuracy
1. Set the laser to an inclination of 0.000%.
2. Set up a leveling staff at a distance of 1 m (3.3") from the laser tool and another leveling staff at a distance
of 60 m (196.85").
3. Make a note of the heights at which the laser beam strikes the leveling staffs.
4. Set up an optical level in the middle between the two leveling staffs and read the heights from both staffs.
5. Calculate the difference between the height readings from the optical level and the laser beam at staffs
1 and 2.
◁
If both values are identical, the laser tool is correctly adjusted.
Note
If the differences X1 and X2 are not within tolerance, please contact your local Hilti Center or
representative.
6 Care and maintenance
6.1 Cleaning and drying
1. Blow any dust away from the lens.
Note
Do not touch the glass with the fingers.
2. Clean the tool.
Note
Use only a soft, clean cloth.
If necessary, use a pure alcohol or a little water. Do not use any other liquids as these may damage
the plastic parts.
6.2 Storage and drying
▶
Do not put the product into storage when wet. Allow it to dry before putting it away.
Printed: 06.06.2016 | Doc-Nr: PUB / 5284788 / 000 / 00