g) Magnetic fields may affect the accuracy of the tool. It
must thus be kept away from magnetic objects. The
tool is not affected by the Hilti universal adapter.
5.3 Electromagnetic compatibility
NOTE
Only for Korea: This is a Class B Device and is registered
for EMC requirements for residential use. This device can
be used not only in residential areas but in all other areas.
Although the tool complies with the strict requirements
of the applicable directives, Hilti cannot entirely rule out
the possibility of the tool being subject to interference
caused by powerful electromagnetic radiation, leading
to incorrect operation. Check the accuracy of the tool
by taking measurements by other means when working
under such conditions or if you are unsure. Likewise, Hilti
cannot rule out the possibility of interference with other
devices (e.g. aircraft navigation equipment).
5.4 Laser classification for laser class 2 / class II
appliances
Depending on the version purchased, the tool complies
with Laser Class 2 in accordance with IEC825-1:2007 /
EN60825-1:2007 and Class II in accordance with CFR
21 § 1040 (FDA). This tool may be used without need
for further protective measures. The eyelid closure reflex
protects the eyes when a person looks into the beam
unintentionally for a brief moment. This eyelid closure
reflex, however, may be negatively affected by medicines,
alcohol or drugs. Nevertheless, as with the sun, one
should not look directly into sources of bright light. Do
not direct the laser beam toward persons.
5.5 Electrical
a) Insulate or remove the batteries before shipping the
tool.
b)
To avoid pollution of the environment, the tool
must be disposed of in accordance with the cur-
rently applicable national regulations. Consult the
manufacturer if you are unsure of how to proceed.
c)
Keep the batteries out of reach of children.
d)
Do not allow the batteries to overheat and do not
expose them to fire.
The batteries may explode or
release toxic substances.
e)
Do not charge the batteries.
f)
Do not solder the batteries into the tool.
g)
Do not discharge the batteries by short circuiting
as this may cause them to overheat and present
a risk of personal injury (burns).
h)
Do not attempt to open the batteries and do not
subject them to excessive mechanical stress.
i)
Do not use damaged batteries.
j)
Do not mix old and new batteries. Do not mix
batteries of different makes or types.
5.6 Liquids
Under abusive conditions, liquid may leak from the bat-
tery.
Avoid contact. If contact accidentally occurs,
flush with water. In the event of the liquid coming into
contact with the eyes, rinse the eyes with plenty of
water and consult a doctor.
Liquid ejected from the
battery may cause irritation or burns.
6 Before use
6.1 Inserting the batteries
2
DANGER
Use only new batteries.
1. Open the battery compartment.
2. Remove the batteries from the packaging and insert
them in the tool.
NOTE
Only batteries recommended by Hilti may be
used to power the tool.
3. Check that the battery terminals are positioned cor-
rectly as shown on the underside of the unit.
4. Close the battery compartment. Check that the
catch engages properly.
7 Operation
7.1 Operation
7.1.1 Switching the laser beams on
Slide the on/off switch backwards.
7.1.2 Switching the tool / laser beams off
Slide the on/off switch forwards.
NOTE
The tool switches itself off automatically after approx. 15
min.
en
5
Printed: 08.07.2013 | Doc-Nr: PUB / 5130772 / 000 / 01
