Brass Screw cap M36 x 1,
Lens 45 mm assy (Dummy Front Cap, Line Generating Front Cap, Cross Generating Front Cap)
O-ring 28 x 4 (2 pcs). + 24 x 3 mm (2 pcs.)
2
en
2. Description
The water resistant PL MG-IS Line Laser features a 532
nM/Class IIIa, max. 5 mW, Ultra bright, highly visible green
beam with extended range. It is durable and impact resis-
tant. Use 2 x D Cell Batteries. Hilti recommend the use of
Duracell D-Cell 1.5 V Alkaline batteries in this product.
The PL MG-IS Line Laser is a portable device, with a 304
stainless steel tubular outer housing and a nylon inner sleeve.
The housing has an overall length of 400 mm and a diam-
eter of 45 mm. The rear part of the pvc inner sleeve serves
as the battery compartment which houses two size D-Dura-
cell 1.5 V Alkaline batteries. A brass screw-on cover a the
rear serves simultaneously as battery compartment cover,
positive connection for the batteries and on/off switch. The
laser is mounted at the other (front) end of the housing. An
O-ring at the front-end ensures that no ingress will enter the
unit via the laser aperture.
2.1 Compliance
The unit as described above and examined in the Test Report
NO: SAEx 09-098 is certified “Explosion Protected” EX Ib
I/IIC T6, and is suitable for use in hazardous locations as
stated below, as determined during inspections conducted
in accordance with the relevant requirements of SANS Stan-
dards:
SANS/IEC 60079: „Electrical apparatus for explosive gas
atmospheres“,
- Part 0: 2005, “General requirements” and
- Part 11: 2007, “Equipment Protected by Intrinsic Safety
‘I’”.
Locations Zone 1 and 2 Mining and Surface
Hazardous Frequency Intermittent as could occur under
normal operations
Environment Group IIC Propane to Hydrogen (Excluding
acetylene)
Limiting Temperature T6
Ambient Temperature -20°C to 40°C
The use of the apparatus in hazardous locations is subject
to the following provision, which shall be adhered to:
ii
i) SANS 10086 requirements;
i
ii) Any relevant requirements of the MHS Act or the OHS
Act;
iii) Codes of Practice enforced in terms of Regulations 21.17/2
of the Minerals Act, by the Chief Inspector of Mines;
iv) Any restrictions and conditions enforced by the Chief
Inspector of Mines, Principal Inspector (Group I equip-
ment) or Chief Inspector of Factories (Group II equip-
ment).
2.2 Items supplied with the cardboard box version
1 Line laser
1 Lens 45 mm assy (Dummy Front Cap, Line Generating
Front Cap, Cross Generating Front Cap)
1 Soft pouch
2 Batteries
1 Operating instructions
3. Accessories
Wavelength
532 nm
Optical Output Power
max. 5 mW
Sta/-5%
Transverse Mode
TEMOO
Laser Class:
IIIa
Laser Operation
Continuous
Laser Beam diam. at source
1.0 mm
Laser Beam Divergence
<1 milliradians
4. Technical data
Printed: 03.09.2013 | Doc-Nr: PUB / 5153539 / 000 / 00
