Hilti NURON SD 5000-22, Оригинальная инструкция по эксплуатации, Страница: 22 / 84

16 English 2293285
*2293285*
isolated from any conductive materials or other batteries that may come
in contact with the terminals and cause a short circuit. Comply with the
locally applicable regulations for transporting batteries.
▶
Do not send batteries through the mail. Consult your shipper for
instructions on how to ship undamaged batteries.
▶
Prior to each use and before and after prolonged transport, check the
product and the batteries for damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶
Always store your products with the batteries removed!
▶
Store the product and the batteries in a cool and dry place. Comply with
the temperature limits stated in the technical data.
▶
Do not store batteries on the charger. Always remove the battery from
the charger when the charging operation has completed.
▶
Never leave batteries in direct sunlight, on sources of heat, or behind
glass.
▶
Store the product and batteries where they cannot be accessed by
children or unauthorized persons.
▶
Prior to each use and before and after prolonged storage, check the
product and the batteries for damage.
9 Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of
the battery. See the section headed Status indicators of the Li­ion battery .
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
Product does not
work.
Low battery.
▶
Charge the battery.
→ page 11
The battery is not fully
inserted.
▶
Insert the battery.
→ page 12
Screw is not com-
pletely offset and
tool stops.
The depth gauge is set
incorrectly.
▶
Adjust the depth
gauge.
The control switch
can’t be pressed, i.e.
the switch is locked.
The switch-on interlock
is activated.
▶
Set the
forward/reverse
switch to forward or
reverse rotation, as
applicable. → page 13