Hilti DX 76, Руководство пользователя

Страница: 35 / 204

*282470*
282470 English 29
Malfunction Possible cause Action to be taken
Firing not possible Trigger pulled before the tool is
fully pressed down
▶
Press the fastening tool fully
against the work surface and
then pull the trigger.
Fastener transport malfunctions
▶
Remove the fastener strip.
▶
Check the fastener strip for
damage.
▶
Replace damaged fastener
strips.
Fastening tool is damaged
▶
Contact Hilti Service.
The magazine or fastener guide is
not screwed on far enough.
▶
Screw the magazine tighter.
No fastener driven Fastening tool was not cycled cor-
rectly, the cycling grip is not in the
starting position
▶
Cycle the fastening tool com-
pletely and set the cycling grip
to the starting position.
No fastener inserted in the tool
▶
Insert a fastener into the
fastening tool.
Magazine nail transport mecha-
nism is faulty
▶
Contact Hilti Service.
No piston inserted in the tool
▶
Insert the piston into the
fastening tool.
The piston is broken
▶
Change the piston and the
piston brake.
Piston does not return
▶
Contact Hilti Service.
Fastener guide is dirty
▶
Service the tool.
Fasteners jammed in the fastener
guide
▶
Remove jammed fasteners.
Remove plastic residues from
the tool magazine. Avoid shear
breakages and misfires.
The fastener guide can’t be
screwed on to the tool fully.
Fastener guide is dirty
▶
Service the tool.
Piston stopper is installed the
wrong way round.
▶
Unscrew the fastener guide.
Install the piston stopper right
way round and screw the piston
guide back on.
The piston can’t be fitted. Fastening tool, especially the pis-
ton guide, is dirty
▶
Service the tool.
Pins are visible in the piston guide
▶
Pull the cycling lever back until
the pins can engage.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
11 Manufacturer’s warranty
▶
Please contact your local Hilti representative if you have questions about the warranty conditions.
12 C.I.P. test confirmation
The following applies to C.I.P. member states outside the EU and EFTA judicial areas: The Hilti DX 76
has been system and type tested. As a result, the tool bears the rectangular PTB approval mark showing
approval number S 813. Hilti thus guarantees compliance with the approved type.