Hilti DX 6, Оригинальная инструкция по эксплуатации

Страница: 26 / 88

18 English 2232123
*2232123*
Malfunction Possible cause Action to be taken
Fastener breakage
(with deformation)
Too much driving energy.
▶
Turn the selector ring for driving
energy to reduce driving energy.
The head of the nail punches
through the material fastened
Too much driving energy
▶
Turn the selector ring to reduce
driving energy.
▶
Use a less powerful cartridge
(titanium-gray).
9.2 Problems with the cartridges
Malfunction Possible cause Action to be taken
The cartridge strip doesn’t
advance
The cartridge strip is damaged.
▶
Change the cartridge strip.
Excessive build-up of foreign mat-
ter on the fastening tool.
▶
Clean the fastening tool.
▶
If necessary, have the fastening
tool checked by Hilti Service.
Fastening tool damaged.
▶
Contact Hilti Service.
Wrong cartridge strip used
▶
Use only cartridge strips of a
type intended for use with the
fastening tool.
Cartridge strip is difficult to
remove.
Fastening tool overheated.
▶
Allow the fastening tool to
cool down under constant
observation.
▶
Subsequently, carefully remove
the cartridge strip from the
fastening tool.
Build-up of combustion residues.
▶
Service the tool.
▶
Clean the cartridge chamber.
▶
Insert new cartridge strip.
The cartridge doesn’t fire
Bad cartridge.
▶
Pull the cartridge strip through
to the next cartridge.
Fastening tool dirty.
▶
Service the tool.
The cartridge strip melts
Fastening tool was pressed against
the working surface for too long.
▶
Remove cartridge strip and
insert a new cartridge strip
instead.
▶
Fire the fastening tool sooner
after pressing it against the
working surface.
Fastener driving rate too high (fas-
tening tool overheated).
▶
Stop using the tool immediately.
▶
Remove cartridge strips and
allow the fastening tool to cool
down.
▶
Do not exceed the recom-
mended maximum fastener
driving rate (see the section
headed "Technical data").