Hilti DX 6, Оригинальная инструкция по эксплуатации

Страница: 24 / 88

16 English 2232123
*2232123*
Malfunction Possible cause Action to be taken
The piston jams in the fas-
tener guide
The piston and/or buffer are dam-
aged.
▶
Unscrew the magazine, check
the piston and buffer and
replace if necessary.
Plastic fragments in the magazine.
▶
Open the magazine, remove the
nail strip and plastic fragments.
Too much driving energy
▶
Turn the selector ring for driving
energy to reduce driving energy.
Piston bent because tool fired
without fastener
▶
Avoid firing the tool without a
fastener loaded.
▶
Check the straightness of the
piston; replace if necessary.
The fastener guide in the
magazine jams
The magazine is damaged.
▶
Replace the magazine.
9.1 Problems with fasteners
Malfunction Possible cause Action to be taken
Fastener driving depth varies
Incorrect piston position
▶
Remove the cartridge strip and
service the tool.
▶
Check the piston and buffer and
replace if necessary.
Excessive build-up of foreign mat-
ter on the fastening tool.
▶
Clean the fastening tool.
▶
If necessary, have the fastening
tool checked by Hilti Service.
Piston bounce because driving
energy is too high.
▶
Turn the selector ring for driving
energy to reduce driving energy.
The fastener bends
Hard material (steel, concrete).
▶
Turn the selector ring for driving
energy to increase driving
energy.
▶
Use a shorter nail.
▶
Use a nail with a higher
application limit.
▶
For concrete: Use the DX-Kwik
method (predrilling) → see the
'Direct Fastening Technology
Manual'.
Hard and/or large aggregates in
the concrete.
▶
Use the DX-Kwik method
(predrilling).
A rebar is located just below the
concrete surface.
▶
Drive the fastener at a different
position.
The fastener is not driven
flush
Wrong fastener.
▶
Match the length of the fastener
to the thickness of the compo-
nent.
Wrong power setting.
▶
Change the energy setting on
the fastening tool.
Hard and/or large aggregates in
the concrete.
▶
Use the DX-Kwik method
(predrilling).