Fault
Possible cause
Remedy
Damaged nail head.
Driving power is too high.
Use a less powerful cartridge.
Application limit exceeded (very hard
material).
Use a nail with a higher application
limit.
The piston is damaged.
Change the piston.
The nail doesn’t penetrate
deeply enough.
Driving power is too low.
Use a more powerful cartridge.
Application limit exceeded (very hard
material).
Use a nail with a higher application
limit.
The system is unsuitable.
Use a more powerful system, e.g.
DX 460.
The piston was in the wrong position.
Remove the cartridge strip and cycle
the tool.
See section: 8.5 Cycling the tool
5
The nail doesn’t hold in the
base material.
Thin steel base material
Use a different cartridge.
Use a nail suitable for thin steel base
material.
Steel with a thickness of less than
3 mm (¹⁄₈") is not suitable as a base
material for DX fastening.
Nail breakage.
Driving power is too low.
Use a more powerful cartridge.
Application limit exceeded (very hard
material).
Use a shorter nail.
Use a nail with a higher application
limit.
The system is unsuitable.
Use a more powerful system, e.g.
DX 460.
The head of the nail punches
through the material fastened
(sheet metal).
Driving power is too high.
Use a less powerful cartridge.
Use a nail with a “top hat”.
Use a nail with a washer.
en
12
Printed: 14.08.2014 | Doc-Nr: PUB / 5193679 / 000 / 00
Содержание dx 2
