9
Assembly
Step 6 – Assemble the spreader bars
On the Mini Line there is no Spreader Bar assembly required.
6.1
Dis-assemble the spreader handle from the spreader joiner using the hex key
4mm (
Fig. 7
).
6.2
Insert the spreader joiner into the spreader bar and then fasten with the spreader
handle as shown (
Fig. 8
).
Once the Joiner has been assembled to the first Spreader, fasten one of the screws
to prevent the Joiner slipping in further during the assembly of the second Spreader.
You must ensure the correct orientation of the spreader bars, spreader
joiner and mount holes.
• The spreader joiner is designed to be a tight fit within the spreader bar so you
may need to gently ‘tap’ it in with a hammer. Ensure you protect the other end
of the spreader bar with a cloth, soft surface or the cardboard packaging to
avoid damage.
• Ensure the mount holes and fasteners align.
• If you accidentally insert the spreader joiner too far you can ‘lever’ it out using
a screwdriver. (
Fig. 9
).
Fig. 8
Spreader joiner
Tap gently with
a hammer
Spreader bar
Mount hole
Fastener
Spreader handle
Fig. 7
Spreader joiner
Spreader handle
Fastener
Hex key 4mm
Protect this end
Fig. 9
Lever gently
with a screwdriver
