2
www.liko.com
Transfer Motor Likorall ES • 7EN120112-05
Before lifting always make sure that:
• the lift battery is charged
• the Transfer motor can be runned in both directions
of travel.
Safety Instructions
Table of Contents
Before using
the first time
make sure that:
• the functions of the lift and transfer motor
correspond to the markings of the hand control,
• the lifting accessories is properly attached to the lift,
• you have read the instruction guides for the lift and
lifting accessories,
• personnel using the lift are informed of the correct
use of the lift and lifting accessories.
NOTE!
This instruction guide contains important information for the user of the product.
All who use the product should review and completely understand the contents of the instruction guide.
Remember to keep the instruction guide in a place where it is always available to those using the product.
Technical Data
Accessories
MultiStation
Prod. No. 3126110
As an alternative to charging via the hand control,
the Likorall with transfer motor can charge the batteries
via a MultiStation. The MultiStation is installed on the
rail system. By parking the lift in the charging position
under the MultiStation (i.e. the MultiStation touches
the contact plate on the transfer motor) charging
of the batteries occurs.
Safety Instructions ............................................................ 2
Technical Data .................................................................. 2
Accessories ...................................................................... 2
Definitions
......................................................................... 3
Operation ........................................................................... 3
Simple Troubleshooting ..................................................... 3
Inspection and Maintenance.............................................. 4
Maximum load:
250 kg / 500 Ibs.
Drive speed:
27 cm/s, 10.6 in/s
Electronics:
Uses Likorall’s battery and
electronics, 24 V, 5 A.
Material:
Aluminium and plastic.
Sound level:
58dB(A)
Intermittent
operation:
Int. Op 10/90, active operation max 0.5 min.
Protection Class:
IPX4
The device is intended for indoor use.
Type B, in accordance with the electrical shock protection class.
Transfer Motor
dimensions:
A = 233 mm / 9.2 inches
B = 148 mm / 5.8 inches
C = 126 mm / 5.0 inches
H = 65 mm / 2.6 inches
Transfer Motor
Weight:
2,2 kg / 4,8 lbs
Transfer Motor Likorall ES in combination with Liko lift motors Likorall complies with the requirements in EN ISO
10535:2006, IEC 60601-1, EN 60601-1-2, ANSI/AAMI ES60601-1 and CAN/CSA C22.2 No. 60601-1.
Installation of Likorall to carriages shall be made by personnel authorized by Liko in accordance
with the installation instructions and recommendations for the current lift system.
H
B
C
A
