7
6
PAGE 4
Controls and Connections
USER MANUAL - PMA1020 PRECISION 2-WAY WIRELESS ACTIVE PA SYSTEM
2
1
1
4
5
3
6
7
230V
2
3
4
5
AC inlet. Use the supplied AC cord to connect the unit to AC mains. Make sure voltage and
frequency stated and set on the unit comply with your local AC supply.
AC Voltage Selector Switch. Switches the AC supply voltage between 110/115V and
220/230V AC.
The product ought to be preset to the voltage of your location, but it is recom-
mended to check this before first operation. Available settings are 230V and 115V.
FUSE holder. The fuse can be removed and exchanged by turning the holder and pulling out the
holder tray. Switch the unit off and disconnect the AC supply before doing so. Replace fuses
only with same value and rating. If the fuse blows a second time, submit product for repair.
POWER switch. Turns the product on and off. Make sure you switch the unit off when not in
use.
Battery CHARGING indicator. This LED illuminates red when the internal battery is being
charged. It takes approximately eight hours to fully charge the battery. Before using the
PMA1020 with the battery for the first time, charge the battery eight hours.
These four LEDs indicate the status of the internal battery. 100% indicates that the battery is
fully charged, providing up to 10 hours of battery life, depending on the usage. LOW indicates
that the battery life is not enough for the system to keep on working properly, in which case the
battery ought to be charged.
LINK output connector. This is a ¼" TRS jack to supply a line-level balanced audio signal to
external speakers, like the Andante series.
