Hilberling PT-8000, Руководство по эксплуатации

Страница: 23 / 82

PT-8000 A·B·C User Manual
C–13
7
I
N S T A L L A T I O N
A
N D
C
O N N E C T I O N S
Prior to any operation of the PT-8000 read this Operation Manual carefully.
The PT-8000 will be delivered with the following presettings:
•
The preselector is aligned and all data’s are stored in RX-CPU memory which is buffered through
a NiCd battery
•
The transmitter is limited to the frequencies in compliance with FCC regulations
The default values for the operation variables are (these default values are set after a hard reset as well)
TBD
Prior applying main power to the power supply HN-8000 verify:
Rear panel
•
Antenna(s) are connected properly
•
Grounding stud is connected to station ground
•
Grounding wire is connected to both PT-8000 and HN-8000
•
DC-cable is connected to both HN-8000 and PT-8000
For initial operation we recommend not to connect external amplifier, transverter or devices for remote
operation.
Front panel
•
Microphone attached
These controls ahould be set fully counter clockwise:
•
Volume controls MAIN/SUB
•
TX-RWR
•
MIC-GAIN
•
PROC
Power ON sequence PT-8000
•
Turn ON both LINE and PA on HN-8000
•
Turn ON POWER at PT-8000
The POWER switch at the PT-8000 does not switch the voltage from the PA
power supply. This is done by the PA switch at the HN-8000 only.
It is up to the operator to switch PA OFF during reception only.
8 F
R O N T P A N E L
C
O N T R O L S
, D
I S P L A Y A N D T H E I R
F
U N C T I O N
8.1 Front Panel Controls
Volume MAIN- and SUB-RX
Speaker ON OFF