Sliding gate opener SLG5400XAC/SLG5550XAC (SL07X0)user manual
10
Figure 10
The installation of magnetic limit switch block is shown in Figure 11:
M6×18
M6×18
M6×18
M6×18
Left side mounting
Right side mounting
Figure 11
Note: The default setting is right side mounting.
(According to actual situation, please refer to the
“
Note
” of section 5.1 to adjust.)
5. Control board wiring
5.1
The opener should be install on the left side of the sliding door because it is set as clockwise
when delivery. If needs to install on the right side of the sliding door, the DIP switch 3 should be
changed into the opposite side.
5.2
Disconnect the power and connect the wires by professionals
5.3
Open the top cover of the motor, and connect the wires according to the following figure (user
just connects the interfaces of AC input, flash lamp, external control switch, photocell and
24VAC output), then install the top cover again after debugging.
