4
4.6 Anti-theft switch: It connects NC switch and J5 port is at 23VDC alarm. It will the alarm if the door is forced
to open when the door is closed to the limit. The port could be short circuit by shorting stub if this function is
unused
V. Setting up process
5.1.Single remote button control: press-open-press-stop-press-close-press-stop
5.2
.
Erasing transmitter: Press the learning button, continue pressing for 8s until light turns off; Release
learning button, light will be on (about 1s) and then off; The erasing process is successful.(ignore this step if
transmitter already matches the opener before delivery)
5.3
．
Learning transmitter: Press learning button S2 in the board, LED 2 turns on and it enters into the learning
/memorizing transmitter process; press the same button twice in transmitter, light blinks for several times,
then off. The learning process is successful (ignore this step if transmitter already matches the opener already).
5.4
．
Limit is wrong: 1,check if the wires of the limit are connecting well or connect the other way. 2, make sure
the door can touch the limit switch when open or close the door fully.
5.5
．
Photocell protect switch: 1, Only work when closing.2, connects normally close switch of photocell
protection 3. If the emitter and receiver module work well.(If the contact disconnect when the signed is
blocked)
Learning transmitter:
（
ref 5.3
）
Adjustment
（
Make the resistance
into
medium position before it
）
Direction of opening and closing is correct
Limit of opening and closing door is correct
Direction of opening and
closing is not correct
Resistance adjustment for opening and closing door: Adjust potentiometer
PT1/PT2 to change the opening/closing resistance. Resistance increases
when adjust it C.W .
Finish the set up
Resistance is appropriate
Resistance is not
appropriate
Check
（
ref 5.5
）
Plug the motor wire
in another port
Erasing transmitter:
（
Ref 5.2
）
Photocell works well
Photocell not working
Limit of opening and closing door is not correct
Check
（
ref 5.4
）
Make sure the connection is correct according to the connection diagram
