17/01
CAUTION
1. Propane is highly flammable and under pressure.
2. Do not store in temperatures over 50 °C /120°F
3. Never use a flame to check for leaks. Apply soapy water at all connection joints for no leakage verification by
checking if there are bubbles after fuel supply is turned on. If bubbles are detected, shut off the fuel supply and
return this heater to a certified technician for repair.
4. Keep out of the reach of children at all times.
5. Keep cylinders upright in use and storage for vapor withdrawal.
6. The smell of gas indicates a leak. Close valves and check for leaks by brushing soapy water on all joints. There
is a leak if bubbles appear. Tighten the joint until the bubbles quit.
7. Always check all connections for dirt or damage before assembling.
8. Do not leave heater unattended while in use.
9. Always detach propane cylinder when stove is not in use.
10. The intended use of this heater is primarily the temporary heating of buildings under construction, alteration or
repair.
11.
These heaters are equipped with an automatic safety shutoff valve. The gas flow will automatically stop if the
heater fails to operate for any reason.
12.
This heater was designed and certified for use as a construction heater in accordance with ANSI Standard
Z83.7/CSA 2.14
13.
Always operate the heater with the propane cylinder in an upright position on a level non-combustible surface.
NEVER place the cylinder on its side when operating the heater.
14.
NEVER attempt to light the heater with a spark lighter.
15.
DO NOT TRANSPORT OR MOVE APPLIANCE WHILE IN OPERATION. FOLLOW SHUTDOWN AND
STORAGE INSTRUCTIONS TO TRANSPORT OR MOVE THIS APPLIANCE.
ASSEMBLY
1.
This heater must be used only with a vapor withdrawal LP gas bulk tank equipped with a standard valve-do not
use this heater on propane cylinder greater than 16.4 OZ.
2.
Ensure heater is facing away from tank. Insert regulator connector into tank valve outlet fitting and turn left
(counter clock-wise) until fully tightened. Do not over-tighten.
3.
Operate only on a stable, level surface. Place cylinder into the plastic cylinder base.
4.
The supply pressure as being propane cylinder pressure.
WARNING:
Never direct the heat output of this heater toward any propane tank
within 20 feet.
MODEL
BTU/HR
GAS
TYPE
NORMAL
OPERATING
PROCEDURE
CLEARANCES TO
COMBUSTIBLES
MAX
MIN
195-FF
3,100 2,500 PROPANE
VERTICAL
36-INCH (92 CM)
FROM ALL SIDES
