2
Installation
Before you start:
Please make sure that the device in the package is in good condition and all the assembly parts are included.
Make sure that all the related equipment is power-off during the installation.
Check the specification of the products for the installation environment.
Check whether the power supply is matched with your required output to avoid damage.
Please make sure the wall is strong enough to withstand three times the weight of the camera and the mounting.
If the wall is the cement wall, you need to insert expansion screws before you install the camera. If the wall is the
wooden wall, you can use self-tapping screw to secure the camera.
If the product does not function properly, please contact your dealer or the nearest service center. Do not disassemble
the camera for repair or maintenance by yourself.
2.1
Installation of Type I Camera
Suction Mounting
Secure Screw
Step 1.
Loosen the secure screw of the camera, as
shown in the figure on the left.
Step 2.
Adjust the camera angle.
NOTE:
Here the camera angle is 180°.
180°
Suction Cup Holder
Step 3.
Rotate the suction mounting base according
to the direction of
OPEN
arrow.
Step 4.
Press the suction mounting base.
Step 5.
Hold and rotate the suction mounting base to
the end according to the direction of
CLOSE
arrow to fix the camera.
Step 6.
Secure the camera by tightening the secure
screw.
NOTE:
Take apart the camera by lifting the suction cup
holder.
