HIKVISION Mini Analog Speed Dome, Руководство пользователя, Страница: 15 / 42

User Manual of Mini Analog Speed Dome
© Hikvision . All Rights Reserved.
14
If the SOFT ADDR is set to OFF , the hard address set by the DIP switch is the valid address of the
speed dome.
Task 2: Set the broadcast address of the speed dome.
When the BROADCAST ADDRESS is set to ON , the control devices with address 0 can control the
speed dome remotely regardless of the address of the speed dome.
With this function on, the control device with address 0 is capable of controlling all domes
connected to it. This function is usually for debugging.

Soft baudrate settings
If the SOFT BAUD ACT is set as ON , the soft baudrate is the valid baudrate for the speed dome, with
2400, 4800, 9600 and 19200 selectable.
If the
SOFT BAUD ACT is set as OFF , the baudrate should be set by the DIP switch.
Note: After you enable/disable the soft baudrate, the speed dome will reboot automatically to
activate the settings.

PELCO checksum
If the speed dome uses PELCO-P or PELCO-D protocol, you can set the PELCO CHECKSUM as ON for
improving the controlling effect.

System time configuration
Steps:
(1) Move the cursor to SYS TIME using the direction buttons and click IRIS+ to enter.
(2) Click the left/right direction buttons to position the cursor on the specific item
(year/month/day or hour/minute/second) of which you want to change the value.
(3) Click the up/down direction buttons to increase/decrease the value.
(4) Click IRIS+ button to confirm and exit.
Y - M - D 07 01 18
H - M - S 15 33 25
DONE: OPEN
QUIT: CLOSE
Figure 3-5 Set the System Time

Zero angle (initial position) configuration
Purpose:
You can define the initial position in the panning direction on the ZERO ANGLE submenu.
Steps:
1. Move the cursor to ZERO ANGLE using the direction buttons and click IRIS+ to enter.
2. Click the left/right/up/down direction buttons to adjust the view angle.