Network Traffic Speed Dome
·
Quick Start Guide
5
Wall Mounting
The network speed dome supports different mounting methods, including wall
mounting, column mounting, corner mounting, pedant mounting, etc. We will take wall
mounting as an example in this Manual.
Notes:
For cement wall, you need to use the expansion screw to fix the bracket.
For wooden wall, you can just use the self-tapping screw to fix the bracket.
Make sure that the wall is strong enough to withstand more than eight times the
weight of the speed dome and the accessories.
The bracket in Figure 2-2 is the recommended bracket for this series of speed dome,
and a pendent adapter is required if any other bracket is selected. The dimension of
pendant adapter is G1
1
2
.
2.1
Installing Type I Speed Dome
Steps:
1.
Install the bracket.
1)
Drill four Φ12 holes for expansion screws in the wall according to the holes of
the bracket, and then insert four M8 expansion screws into the mounting holes.
2)
Route the cables from the bracket body, and hook the bracket to the wall by
aligning the four screw holes of the bracket with expansion screws on the wall.
3)
Secure the bracket with four hex nuts and washers.
Figure 2-2
Install the Bracket
2.
Install the memory card.
1)
Loosen the two lock screws on both sides of the speed dome.
2)
Pull the bubble carefully to separate it from the back box, and remove the
protective material EPE as shown in Figure 2-3.
Do not remove the lock screws from the speed dome.
