Full high turnstile • User Manual
18
3. Changing the square solenoid.
4. Replace a new board.
Q6
：
Rod can't turn 90 degrees or 120 degree for one pass
？
Reasons:
1. The position sensor is too close to the wheel;
2. If the speed go through is too slow and times out.
Solution:
1. Open the cover of to box , adjust position senosr
2. Set DIP switch
Q7
：
It is hard to push the shaft rotation
？
Reasons: 1. Bottom bearing rust or damage; 2. The shaft is not vertical
Solution: 1. Replace new bearing 2. Adjust the shaft to vertical
Maintenance
Full high turnstile require regular maintenance by professionals and daily cleaning to ensure long-term
stability and extended equipment life.
1. Maintenance Content:
Keep the turnstile housing and card reader panels of turnstile gates clean;
Fasten and lubricate the internal movement structure;
Check the dust of the driver board and make it cleans.
Check the connectors and wiring points to ensure the reliability of the connection.
Check the bearings at the bottom of the shaft
2 Maintenance Methods:
1. Cleaning: Check the housing and card reader panels of the gate, and remove the dust and other dirt
to make them clean;wipe rust inhibitor to keep stainless steel bright
2. Rust removal and Lubrication: Check the movement of the flap /slide gate and swing gate, remove
